Knowledge

Debugging method of centrifugal fan

Apr 03, 2021 Leave a message

The centrifugal fan is a complex equipment, mainly composed of air inlet, air valve, impeller, motor, and air outlet. Under different conditions, the centrifugal fan has different effects. Therefore, the operating conditions of different parts are not uniform, and the effect of the centrifugal fan will be affected. To debug the centrifugal fan to the best condition, you can start from many aspects.

1. The centrifugal fan allows full-voltage start or reduced-voltage electric, but it should be noted that the current at full-voltage start is about 5-7 times the rated current, and the reduced-voltage starting torque is proportional to the square of the voltage. When the grid capacity is insufficient, Start with reduced voltage.

2. When the centrifugal fan is in the trial run, you should carefully read the product manual to check whether the wiring method is consistent with the wiring diagram; carefully check whether the working voltage of the power supply to the fan meets the requirements, whether the power supply is lack of phase or the same phase, and the power distribution components Whether the capacity meets the requirements.

3. During the test run, there are no less than two people. One person controls the power supply, and the other observes the operation of the fan. If any abnormal phenomenon is found, the machine will be shut down and checked immediately; first check whether the direction of rotation is correct; after the centrifugal fan starts to run, check whether the operating current of each phase is balanced. ,Whether the current exceeds the rated current; if there is any abnormality, stop the machine for inspection. After running for five minutes, stop the machine and check whether the fan is abnormal, and then start the machine after confirming that there is no abnormality. 

 

 

Send Inquiry